Home › Engine / Hybrid System › 1GR-FE (ENGINE MECHANICAL) › DRIVE BELT
RM25T0E _51 Engine / Hybrid System _029891 1GR-FE ENGINE MECHANICAL _0136553 DRIVE BELT A

1GR-FE ENGINE MECHANICAL  DRIVE BELT  INSTALLATION  


PROCEDURE

Hide 16361A 1.INSTALL FAN AND GENERATOR V BELT

HINT:

When reusing the fan and generator V belt, check the circumference for wear or cracked back and ribs. Replace any belts with wear or cracked ribs that have reached the core (at 1 point or more) and belts with missing rubber ribs (at 1 point or more).


a.
A270807C01
2.302,1.083 2.635,1.083 true 0.438,0.781 0.75,0.938 0.313,0.156 10 false *1 1.5,0.75 1.813,0.906 0.313,0.156 10 false *2 2.333,0.563 2.646,0.719 0.313,0.156 10 false *3 3.031,0.656 3.344,0.813 0.313,0.156 10 false *4 2.813,1.458 3.125,1.615 0.313,0.156 10 false *5 2.208,1.542 2.521,1.698 0.313,0.156 10 false *6 1.5,1.427 1.813,1.583 0.313,0.156 10 false *7 2.688,1.01 3,1.167 0.313,0.156 10 false *8 0.979,1.073 1.292,1.229 0.313,0.156 10 false *3
*1 Vane Pump Assembly
*2 Engine Water Pump Assembly
*3 No. 2 Idler Pulley
*4 Generator Assembly
*5 Cooler Compressor Assembly
*6 No. 1 Idler Pulley
*7 Crankshaft Pulley
*8 V-ribbed Belt Tensioner Assembly


Set the fan and generator V belt onto each part.


b.

While turning the belt tensioner counterclockwise, remove the bar.

NOTICE:

Make sure that the fan and generator V belt is properly installed to each pulley.



c.

Check that the belt fits properly in the ribbed grooves.

HINT:

Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.