Home › Engine / Hybrid System › 1GR-FE (ENGINE MECHANICAL) › CYLINDER HEAD
RM25T0E _51 Engine / Hybrid System _029891 1GR-FE ENGINE MECHANICAL _0136561 CYLINDER HEAD A

1GR-FE ENGINE MECHANICAL  CYLINDER HEAD  REPAIR  


PROCEDURE

Hide 13734 1.REPAIR VALVE SPRING SEAT

a.
A326716C01
2.24,0.927 2.729,0.927 true 2.063,0.823 2.375,0.979 0.313,0.156 10 false *a 3.094,0.833 3.406,0.99 0.313,0.156 10 false *b 2.854,1.198 3.167,1.354 0.313,0.156 10 false *c
*a 45°
*b 30°
*c 1.0 to 1.4 mm (0.0394 to 0.0551 in.)


If the seating is too high on the valve face, use 30° and 45° cutters to correct the seat.


b.
A326717C01
2.031,0.865 2.781,0.865 true 1.844,0.781 2.156,0.938 0.313,0.156 10 false *a 3.073,0.698 3.385,0.854 0.313,0.156 10 false *b 2.865,1.25 3.177,1.406 0.313,0.156 10 false *c
*a 60°
*b 45°
*c 1.0 to 1.4 mm (0.0394 to 0.0551 in.)


Intake Side:

If the seating is too low on the valve face, use 60° and 45° cutters to correct the seat.


c.
A326718C01
1.854,0.688 2.646,0.688 true 1.656,0.594 1.969,0.75 0.313,0.156 10 false *a 3.083,0.708 3.396,0.865 0.313,0.156 10 false *b 2.875,1.25 3.188,1.406 0.313,0.156 10 false *c
*a 75°
*b 45°
*c 1.0 to 1.4 mm (0.0394 to 0.0551 in.)


Exhaust Side:

If the seating is too low on the valve face, use 75° and 45° cutters to correct the seat.


d.
A326719

Hand-lap the valve and valve seat with an abrasive compound.


e.

After lapping the valve by hand, clean the valve and valve seat.