31301 1.INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY
| *a | Push Rod Play Adjustment Point |
| *b | Pedal Height Adjustment Point |
| *c | Pedal Height |
Check that the pedal height is correct.
185 to 195 mm (7.29 to 7.67 in.)
Adjust the pedal height.
for 1VD-FTV:
Loosen the lock nut and turn the clutch switch assembly until the height is correct. Tighten the lock nut.
for 1GR-FE, 1HZ:
Loosen the lock nut and turn the clutch pedal stopper bolt until the height is correct. Tighten the lock nut.
| *a | Push Rod Play |
| *b | Pedal Free Play |
Check that the pedal free play and push rod play are correct.
Pay close attention to the change in resistance to distinguish between pedal free play and push rod play while performing the inspection.
Depress the pedal until the clutch resistance begins to be felt.
5.0 to 15.0 mm (0.197 to 0.590 in.)
Gently depress the pedal until the resistance begins to increase a little.
1.0 to 5.0 mm (0.0394 to 0.1968 in.)
Adjust the pedal free play and push rod play.
The push rod play can be adjusted by changing the length of the push rod. Pedal free play changes together with push rod play.
Loosen the lock nut and turn the push rod until the pedal free play and push rod play are correct.
If pedal free play and push rod play are not within the standard range even after adjustment, inspect the related parts.
Tighten the lock nut.
After adjusting the pedal free play and push rod play, check the pedal height.
185 to 195 mm (7.29 to 7.67 in.)
| *a | 25 mm (0.984 in.) or more |
| *b | Release Point |
| *c | Pedal Stroke |
| *d | Full Stroke End Position |
Check the clutch release point.
Pull the parking brake lever and chock the wheels.
Start the engine and allow it to idle.
Without depressing the clutch pedal, slowly move the shift lever into the reverse position until the gears engage.
Gradually depress the clutch pedal and measure the stroke distance from the point that the gear noise stops (release point) up to the full stroke end position.
25 mm (0.984 in.) or more.
If the distance is not as specified, perform the following operations:
Check the pedal height.
Check the push rod play and pedal free play.
Bleed the clutch line.
Check the clutch cover and disc.