Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER (for RHD)
RM25T0E _52 Drivetrain _029901 CLUTCH _0136567 CLUTCH MASTER CYLINDER(for RHD) A

CLUTCH  CLUTCH MASTER CYLINDER(for RHD)  REASSEMBLY  


PROCEDURE

Hide 31490 1.INSTALL CLUTCH ACCUMULATOR ASSEMBLY (for 1GR-FE, 1HZ)

Hide 2.INSTALL PISTON AND SPRING

a.
C163276C02
0,0 0,0 false
V100135

Lithium soap base glycol grease


Apply lithium soap base glycol grease to a new piston.


b.

Install the piston and a new spring to the clutch master cylinder body.


Hide 31451 3.INSTALL CLUTCH MASTER CYLINDER PUSH ROD

a.

Install the clutch master cylinder push rod and plate to the clutch master cylinder body.


b.
C163273

Using snap ring pliers, install a new snap ring.


c.

Install a new boot.


Hide 31453 4.INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS

a.

Install the lock nut to the clutch master cylinder push rod.


b.

Install the clutch master cylinder push rod clevis to the clutch master cylinder push rod.


c.
C310624C01
1.792,0.615 2.01,0.615 2.01,0.615 2.104,0.906 false 1.625,0.531 1.938,0.729 0.313,0.198 10 false *1 1.625,1.479 1.938,1.677 0.313,0.198 10 false A
*1 Lock Nut


Tighten the lock nut and check that dimension A is the same as the dimension A that has been measured.

Torque:
11.8 N*m (120 kgf*cm, 9 ft.*lbf)


Hide 31402 5.INSTALL CLUTCH MASTER CYLINDER RESERVOIR SUB-ASSEMBLY

a.
C163277C01
1.823,2.167 2.125,2.385 0.302,0.219 10 false *a 0.281,0.094 0.656,0.375 0.375,0.281 10 false *A 0.438,2.5 0.813,2.771 0.375,0.271 10 false *B 1.833,4.333 2.135,4.552 0.302,0.219 10 false *a
*A w/ Clutch Accumulator
*B w/o Clutch Accumulator
*a 1.5 to 3.5 mm (0.0591 to 0.1377 in.)


Install a new grommet and the clutch master cylinder reservoir sub-assembly.


b.

Using a pin punch and hammer, tap in the slotted spring pin.