Home › Engine / Hybrid System › 1HZ (STARTING) › GLOW PLUG › 2014.08–2022.09
RM25T0E _51 Engine / Hybrid System _029899 1HZ STARTING _0136994 GLOW PLUG A

1HZ STARTING  GLOW PLUG  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 19871 3.REMOVE NO. 1 GLOW PLUG CONNECTOR

a.

Remove the 6 glow plug screw grommets.


b.
A326086

Remove the 6 nuts, No. 1 glow plug connector and disconnect the wire harness.


Hide 19850 4.REMOVE GLOW PLUG ASSEMBLY

a.
A326087

Using a 12 mm deep socket wrench, remove the 6 glow plug assemblies.

NOTICE:

Do not remove the glow plug assembly before warming up the engine.