19850 1.CHECK ILLUMINATION DURATION OF GLOW INDICATOR LIGHT
Check the light illumination duration.
| *a | Light Illumination Duration | *b | Engine Coolant Temperature |
Turn the ignition switch to ON and measure the light illumination duration.
See graph.
If the result is not as specified, check the ECM, engine coolant temperature sensor, glow plug assembly and glow plug relay.
Actual light illumination duration may vary slightly from the graph.
Turn the ignition switch off.
19850 2.CHECK PRE-HEATING
Inspect the pre-heating time.
| *a | Pre-heating Time | *b | Battery Voltage |
Turn the ignition switch to ON. Measure how long it takes for the battery voltage to be applied to the glow plug assemblies.
| Engine Coolant Temperature | Specified Condition |
|---|---|
| 40°C (104°F) or higher | 1 second |
| Below 40°C (104°F) | See graph* (Maximum: 21 seconds) |
*: The pre-heating time changes depending on the battery voltage.
If the result is not as specified, check the ECM, engine coolant temperature sensor, glow plug assembly and glow plug relay.
Turn the ignition switch off.
19850 3.CHECK AFTER GLOW TIME
Remove the No. 1 glow plug relay and No. 2 glow plug relay from the cowl side relay block assembly.
| *a | Front view of wire harness connector (No. 1 Glow Plug Relay) |
*b | Front view of wire harness connector (No. 2 Glow Plug Relay) |
| *c | Cowl Side Relay Block Assembly | *d | Terminal 1 |
After the engine starts, measure the time duration that battery voltage remains present.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Terminal 1 - Body ground | After engine starts | Refer to graph below |
| *a | After Glow Time | *b | Engine Coolant Temperature |
If the result is not as specified, check the ECM, engine coolant temperature sensor, glow plug assembly and glow plug relay.