84450 1.INSPECT IGNITION SWITCH ASSEMBLY
| *a | Component without harness connected (Ignition Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Switch Condition | Tester Connection | Specified Condition |
|---|---|---|
| LOCK | - | 10 kΩ or higher |
| ACC | 1 (AM1) - 3 (ACC) | Below 1 Ω |
| ON | 1 (AM1) - 3 (ACC) 1 (AM1) - 4 (IG1) 7 (IG2) - 8 (AM2) |
Below 1 Ω |
| START | 1 (AM1) - 2 (ST1) 1 (AM1) - 4 (IG1) 6 (ST2) - 8 (AM2) 7 (IG2) - 8 (AM2) |
Below 1 Ω |
If the result is not as specified, replace the ignition switch assembly.