Home › Steering › STEERING GEAR / LINKAGE › STEERING LINKAGE
RM25T0E _55 Steering _029923 STEERING GEAR / LINKAGE _0136923 STEERING LINKAGE G

STEERING GEAR / LINKAGE  STEERING LINKAGE  INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, place aluminum plates between the part and vise.

·

When using a vise, do not overtighten it.



PROCEDURE

Hide 45047 1.INSPECT TIE ROD END SUB-ASSEMBLY LH

C132329

a.

Secure the tie rod end sub-assembly LH in a vise.


b.

Install the castle nut to the stud bolt.


c.

Flip the ball joint back and forth 5 times or more.


d.

Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the 5th turn.

Standard turning torque:

0.7 to 2.7 N*m (8 to 27 kgf*cm, 7 to 23 in.*lbf)


If the turning torque is not within the specified range, replace the tie rod end sub-assembly LH.


Hide 45046 2.INSPECT TIE ROD END SUB-ASSEMBLY RH

HINT:

Use the same procedures described for the LH side.