Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM
RM25T0E _58 Vehicle Interior _029927 METER / GAUGE / DISPLAY _0137559 METER / GAUGE SYSTEM D

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  INITIALIZATION  


T-BELT INFORMATION MODE RESET OPERATION (for 1HZ)


NOTICE:
·

When the T-BELT indicator light is illuminated, replace the timing belt and perform this procedure.

·

After the timing belt is replaced, perform this procedure so that the T-BELT indicator light does not come on.



a.

Turn the ignition switch to ON, and use the ODO/TRIP switch to change the screen display to TRIP B.


b.

Turn the ignition switch to off.


c.

While holding in the ODO/TRIP switch, turn the ignition switch to ON and check that the T-BELT indicator light blinks.


d.

Press and hold the ODO/TRIP switch for 5 seconds or more.

HINT:

If the ODO/TRIP switch is released (off is detected) within 5 seconds, the ODO/TRIP display, indicator display, and the integrated value will return to the state before the reset operation began.



e.

After the ODO/TRIP switch is turned off, turn the ODO/TRIP switch on again within 5 seconds.


f.

After the ODO/TRIP switch is turned on, enter the setting mode and change to T-BELT display mode.


g.

Change the set value in increments by turning the ODO/TRIP switch (the value must be changed within 5 seconds). (procedure A)

NOTICE:

If the ODO/TRIP switch is not turned from on to off for 30 seconds or more during this step, the previously set value will be maintained and the TRIP B display will return (reset will not complete).


HINT:

Perform this procedure only when changing the previously set value.


E157121E11
1.094,0.375 1.969,0.604 0.875,0.229 10 false Unit = "Mile" 1.094,1.552 2.01,1.771 0.917,0.219 10 false Unit = "km" 1.635,0.854 5.844,1.052 4.208,0.198 10 false The last designated value → 1 → 2 → 3.....................18 → 19 → 20 1.635,2.052 5.844,2.25 4.208,0.198 10 false The last designated value → 1 → 2 → 3.....................18 → 19 → 20 2.281,1.208 3.156,1.417 0.875,0.208 10 false (Default = 9) 2.281,2.427 3.25,2.656 0.969,0.229 10 false (Default = 15)


h.

When the display changes to the desired setting, press the ODO/TRIP switch for 5 seconds or more to finish setting mode. (procedure B)


i.

The ODO display area changes to the TRIP B display, the warning indicator turns off simultaneously and reset mode is completed. (procedure C)

NOTICE:

When not changing the previously set value, do not perform the operations in procedure A above, only perform procedures B and C.