69350 1.INSPECT BACK DOOR LOCK ASSEMBLY (w/ Power Back Door)
| *a | Lock |
| *b | Off |
| *c | Unlock |
| *d | Component without harness connected (Back Door Lock Assembly) |
Apply battery voltage to the door lock motor and check the operation of the door lock motor.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 1 Battery negative (-) → 2 |
Lock |
| Battery positive (+) → 2 Battery negative (-) → 1 |
Unlock |
If the result is not as specified, replace the back door lock assembly.
| *a | Lock |
| *b | Off |
| *c | Unlock |
| *d | Component without harness connected (Back Door Lock Assembly) |
Inspect the back door courtesy light switch assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 3 | Lock | Below 1 Ω |
| 1 - 3 | Off | 10 kΩ or higher |
| 1 - 2 | ||
| 1 - 2 | Unlock | Below 1 Ω |
If the result is not as specified, replace the back door lock assembly.
69350 2.INSPECT BACK DOOR LOCK ASSEMBLY (w/o Power Back Door)
| *a | Lock |
| *b | Off |
| *c | Unlock |
| *d | Component without harness connected (Back Door Lock Assembly) |
Inspect the back door lock assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 3 | Lock | Below 1 Ω |
| 1 - 3 | Off | 10 kΩ or higher |
| 1 - 2 | ||
| 1 - 2 | Unlock | Below 1 Ω |
If the result is not as specified, replace the back door lock assembly.
84235 3.INSPECT BACK DOOR COURTESY LIGHT SWITCH ASSEMBLY
| *a | Push |
| *b | Free |
| *c | Component without harness connected (Back Door Courtesy Light Switch Assembly) |
Inspect the back door courtesy light switch assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 3 | Push | Below 1 Ω |
| 1 - 2 | Free | Below 1 Ω |
If the result is not as specified, replace the driver side door lock motor assembly.