Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
85720A 1.INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Using a T25 "TORX" socket wrench, install the front power window regulator motor assembly LH with the 3 "TORX" screws.
For a new front power window regulator motor assembly LH uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
69802 2.INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
68102 3.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH
68141 4.INSTALL FRONT DOOR GLASS RUN
68220A 5.INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP ASSEMBLY LH
67832 6.INSTALL FRONT DOOR SERVICE HOLE COVER LH
69205 7.INSTALL FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY RH (w/ Double Inside Handles)
69759V 8.INSTALL FRONT DOOR LOCK LINK SILENCER
67602 9.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
10.INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
11.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
68278B 12.INSTALL DOOR INSIDE HANDLE BEZEL (w/ Double Inside Handles)
69206B 13.INSTALL FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY
14.CHECK POWER WINDOW
15.CONNECT CABLE FROM NEGATIVE BATTERY TERMINAL