Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
62910J 1.INSTALL SIDE WINDOW LOCK ASSEMBLY LH
Install the side window lock assembly LH, side window plate LH, side window lock packing LH and side window lock retainer LH with the 2 screws.
| *1 | Side Window Lock Assembly LH | *2 | Side Window Plate LH |
| *3 | Side Window Lock Packing LH | *4 | Side Window Lock Retainer LH |
62724D 2.INSTALL SIDE FRONT WINDOW GLASS STOP LH
Install the side front window glass stop LH with screw.
62756E 3.INSTALL QUARTER WINDOW RUN LH
Install the quarter window run LH as shown in the illustration.
62714 4.INSTALL REAR QUARTER WINDOW GLASS LH
Pull apart the quarter window frame sub assembly LH, install the rear quarter window glass LH as shown in the illustration.
62712L 5.INSTALL FRONT QUARTER WINDOW GLASS LH
Use the same procedure described for the rear quarter window glass LH.
67046 6.INSTALL SIDE FRONT WINDOW FRAME SUB-ASSEMBLY CENTER LH
Install the rear window center sash pad LH.
Install the side front window center frame sub-assembly LH with the screw.
62742 7.INSTALL QUARTER WINDOW WEATHERSTRIP LH
Install the quarter window weatherstrip LH.
62712 8.INSTALL QUARTER WINDOW GLASS LH
| *1 | Working Cord |
Apply a working cord along the quarter window weatherstrip LH groove, as shown in the illustration.
| *a | Soapy Water Application Area |
|
Soapy Water Application Area |
Apply soapy water to the contact surface of the vehicle body and the quarter window weatherstrip LH as shown in the illustration.
From the inside, pull one cord at an angle so it pulls the lip over the flange.
Install the quarter window glass LH by pulling the cord from the room side, while pushing quarter window glass LH from the outside with your open hand
Tap from the outside with your open hand.
62720A 9.CHECK FOR LEAKS AND REPAIR
Conduct a leak test after the adhesive has completely hardened.
Seal any leaks with auto glass sealer.