64811 1.INSTALL BACK WINDOW GLASS
| *1 | Working Cord |
Apply a working cord along the back window glass weatherstrip groove, as shown in the illustration.
| *1 | Primer M |
| *2 | Adhesive |
Apply primer to the back window glass weatherstrip on the surface with body as shown in the illustration.
Do not apply too much primer.
Let the primer coating dry for 3 minutes or more.
From the inside, pull one cord at an angle so it pulls the lip over the flange.
Install the back window glass by pulling the cord from the room side, while pushing windshield back window weatherstrip from the outside with your open hand.
Tap from the outside with your open hand.
62720A 2.CHECK FOR LEAKS AND REPAIR
Conduct a leak test after the adhesive has completely hardened.
Seal any leaks with auto glass sealer.