Home › Drivetrain › H150F (MANUAL TRANSMISSION / TRANSAXLE) › BACK-UP LIGHT SWITCH
RM25T0E _52 Drivetrain _029902 H150F MANUAL TRANSMISSION / TRANSAXLE _0137685 BACK-UP LIGHT SWITCH A

H150F MANUAL TRANSMISSION / TRANSAXLE  BACK-UP LIGHT SWITCH  INSTALLATION  


PROCEDURE

Hide 84210 1.INSTALL BACK-UP LIGHT SWITCH ASSEMBLY

a.
C312642C01
0.792,0.438 1.073,0.438 1.073,0.438 1.49,0.99 false 2.292,0.25 1.979,0.25 1.979,0.25 1.677,0.813 false 2.344,0.844 2.656,1.042 0.313,0.198 10 false *a 0.417,0.365 0.875,0.563 0.458,0.198 10 false SST 2.406,0.167 2.865,0.365 0.458,0.198 10 false SST
*a Torque Wrench Fulcrum Length


Using SST, install a new gasket and the back-up light switch assembly to the transmission case.

SST
09817-16011  09961-01270  

Torque:
Specified tightening torque : 44.1 N*m (450 kgf*cm, 33 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 200 mm (7.8740 in.)) + torque wrench (fulcrum length of 380 mm (14.9606 in.)): 28.9 N*m (295 kgf*cm, 21 ft.*lbf)




b.
C313950

Connect the back-up light switch connector clamp to the bracket and connect the wire harness clamp as shown in illustration.


c.

Connect the back-up light switch connector.