33311A 1.INSTALL FRONT INPUT SHAFT BEARING
Using SST and a press, press in a new front input shaft bearing to the input shaft.
Install the input shaft front input shaft bearing so that the snap ring groove is on the front side.
Check that the front input shaft bearing lightly rotates.
33311P 2.INSTALL INPUT SHAFT REAR BEARING SHAFT SNAP RING
Select a snap ring that will allow minimum axial play.
| Mark | Thickness |
|---|---|
| A | 2.50 to 2.55 mm (0.0985 to 0.1003 in.) |
| B | 2.55 to 2.60 mm (0.1004 to 0.1023 in.) |
| C | 2.60 to 2.65 mm (0.1024 to 0.1043 in.) |
| D | 2.65 to 2.70 mm (0.1044 to 0.1062 in.) |
| E | 2.70 to 2.75 mm (0.1063 to 0.1082 in.) |
| F | 2.75 to 2.80 mm (0.1083 to 0.1102 in.) |
Using a snap ring expander, install the front bearing shaft snap ring.