33411A 1.INSTALL FRONT COUNTER GEAR BEARING OR ROLLER
Using SST and a press, press in a new front counter gear bearing or roller to the counter gear.
Install the front counter gear bearing or roller so that the snap ring groove of the bearing faces forward.
33421 2.INSTALL COUNTER GEAR
Select a new snap ring that will allow minimum clearance.
| Mark | Thickness |
|---|---|
| A | 2.45 to 2.50 mm (0.0965 to 0.0984 in.) |
| B | 2.50 to 2.55 mm (0.0985 to 0.1003 in.) |
| C | 2.55 to 2.60 mm (0.1004 to 0.1023 in.) |
| D | 2.60 to 2.65 mm (0.1024 to 0.1043 in.) |
| E | 2.65 to 2.70 mm (0.1044 to 0.1062 in.) |
| F | 2.70 to 2.75 mm (0.1063 to 0.1082 in.) |
Using a snap ring expander, install the snap ring.
After installation, make sure that the front counter gear bearing or roller move smoothly.