52113 1.REMOVE FRONT BUMPER BAR LH (w/ Over Fender)
Remove the front No. 3 bumper bracket plate.
Remove the 4 clips and bumper bar LH.
52112 2.REMOVE FRONT BUMPER BAR RH (w/ Over Fender)
Use the same procedures described for the LH side.
52128B 3.REMOVE FRONT BUMPER HOLE COVER LH (w/o Fog Light)
Detach the 2 claws and remove the front bumper hole cover LH.
52127D 4.REMOVE FRONT BUMPER HOLE COVER RH (w/o Fog Light)
Use the same procedures described for the LH side.
81220 5.REMOVE FOG LIGHT ASSEMBLY LH (w/ Fog Light)
81210A 6.REMOVE FOG LIGHT ASSEMBLY RH (w/ Fog Light)
Use the same procedures described for the LH side.
75111 7.REMOVE FRONT LICENSE PLATE BRACKET (w/ Winch)
Remove the 2 nuts and front license plate bracket.
38649 8.REMOVE WINCH CONTROL WIRE (w/ Winch)
|
Rotation Direction |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
|
Protective Tape |
Using a thin-bladed screwdriver, detach the 2 claws as shown in the illustration.
Tape the thin-bladed screwdriver tip before use.
|
Remove in this Direction (1) |
|
Push in this Direction |
|
Remove in this Direction (2) |
Place your hands on the top of the front bumper winch cover sub-assembly and pull it to detach the 2 claws as shown in the illustration.
Push the part as shown in the illustration to disconnect the fall prevention hook and remove the front bumper winch cover sub-assembly.
Remove the 2 nuts and winch control wire.
52711A 9.REMOVE FRONT BUMPER GARNISH (w/ Garnish)
Remove the 8 clips and front bumper garnish.
75111 10.REMOVE FRONT LICENSE PLATE BRACKET (w/o Winch)
Remove the 2 screws and front license plate bracket.
82132 11.REMOVE NO. 2 COWL WIRE (w/ Fog Light)
Detach the 9 clamps and remove the No. 2 cowl wire.