Use the same procedures for the RH and LH sides.
The procedures listed below are for the LH side.
51774A 1.REMOVE FRONT SIDE DOOR STEP PLATE COVER LH (w/o Over Fender)
Remove the 4 rivets.
Put a 4 mm (0.157 in.) drill bit into a drill.
Wind tape around the drill bit approximately 5 mm (0.197 in.) from the tip of the drill, as shown in the illustration.
Tape the 4 mm (0.157 in.) drill bit to prevent the drill bit from going too deep.
| Area | Specified Condition |
|---|---|
| A | 5 mm (0.197 in.) |
Lightly press the drill bit against the rivets, drill off the flanges of the rivets, and remove the 4 rivets.
Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.
Do not pry the rivets with the drill, as this may cause damage to the installation holes of the rivets or the drill bit.
Be careful of the drilled rivets, as they may become hot.
Using a vacuum cleaner, remove the rivet fragments and shavings from the drilled areas.
Remove the 2 bolts and front side door step plate cover LH.
51774A 2.REMOVE FRONT SIDE DOOR STEP PLATE COVER LH (w/ Over Fender)
Remove the screw, nut and plate cover.
51759A 3.REMOVE REAR SIDE DOOR STEP PLATE COVER LH
Remove the 2 bolts and rear side door step plate cover LH.
51793B 4.REMOVE SIDE STEP BRACKET LH
Remove the 4 bolts and side step bracket LH.
51077B 5.REMOVE NO. 6 SIDE STEP BRACKET SUB-ASSEMBLY LH
Remove the 6 bolts and 3 No. 6 side step bracket sub-assembly LH.
51078B 6.REMOVE NO. 3 SIDE STEP BRACKET SUB-ASSEMBLY LH
Remove the 4 bolts and 2 No. 3 side step bracket sub-assembly LH.