1.INSPECT WINCH MAIN RELAY
Push in the plunger and release it. Check that it returns quickly to its original position.
| *a | Component without harness connected (Winch Main Relay) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A - B | (when battery voltage is not applied to terminals 1 and 2) | 10 MΩ or higher |
| (when battery voltage is applied to terminals 1 and 2) | Below 1 Ω | |
| (Plunger not pressed) | 10 MΩ or higher | |
| (Plunger pressed) | Below 1 Ω |
If the result is not as specified, replace the winch main relay.