Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
53111 1.REMOVE RADIATOR GRILLE ASSEMBLY
53510 2.REMOVE HOOD LOCK ASSEMBLY
for LHD:
Remove the 3 bolts.
Disconnect the hood lock control cable and remove the hood lock.
for RHD:
Remove the 3 bolts.
Disconnect the hood lock control cable and remove the hood lock.
53601 3.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Detach the 3 claws.
Disconnect the hood lock control cable sub-assembly from the hood lock control lever sub-assembly.
53630 4.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)
| *1 | String |
Tie a string to the end of the hood lock control cable assembly as shown in the illustration.
Use a length of string long enough to pass through the engine compartment.
Using a screwdriver, detach the cable from the clamps shown in the illustration.
| *1 | Hood Lock Control Cable Assembly | *2 | Clamp |
| *3 | Washer Hose | *4 | Wire Harness |
Tape the screwdriver tip before use.
Untie the string from the hood lock control cable assembly.
53630 5.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)
| *1 | String |
Tie a string to the end of the hood lock control cable assembly as shown in the illustration.
Use a length of string long enough to pass through the engine compartment.
Using a screwdriver, detach the cable from the clamps shown in the illustration.
| *1 | Hood Lock Control Cable Assembly | *2 | Clamp |
| *3 | Wire Harness | - | - |
| *a | Detach Clamp In Area | - | - |
Tape the screwdriver tip before use.
Untie the string from the hood lock control cable assembly.