A bolt without a torque specification is shown in the standard bolt chart.
53630 1.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)
| *1 | String |
Tie the string that was passed through the engine compartment room to the end of the hood lock control cable assembly as shown in the illustration.
Pass the cable from the vehicle interior into the engine room.
Pass the cable rear side through the grommet until the cable stopper is attached to the grommet.
Pass the cable front side through the upper radiator support.
Attach the cable to the clamps as shown in the illustration.
| *1 | Hood Lock Control Cable Assembly | *2 | Clamp |
| *3 | Washer Hose | *4 | Wire Harness |
53630 2.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)
| *1 | String |
Tie the string that was passed through the engine compartment room to the end of the hood lock control cable assembly as shown in the illustration.
Pass the cable from the vehicle interior into the engine room.
Pass the cable rear side through the grommet until the cable stopper is attached to the grommet.
Pass the cable front side through the upper radiator support.
Attach the cable to the clamps as shown in the illustration.
| *1 | Hood Lock Control Cable Assembly | *2 | Clamp |
| *3 | Wire Harness | - | - |
| *a | Detach Clamp In Area | - | - |
53601 3.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Connect the hood lock control cable assembly to install the hood lock control lever sub-assembly.
Attach the 3 claws to install the hood lock control lever sub-assembly.
53510 4.INSTALL HOOD LOCK ASSEMBLY
Apply MP grease to the sliding areas of the lock.
Connect the hood lock control cable.
Install the hood lock with the 3 bolts.
53111 5.INSTALL RADIATOR GRILLE ASSEMBLY