88467 1.INSTALL PIPING BRACKET LH
Install the piping bracket LH with the 2 bolts.
88467 2.INSTALL PIPING BRACKET RH
Install the piping bracket RH with the 2 bolts.
88467B 3.INSTALL LOWER COOLER BRACKET LH
Install the lower cooler bracket LH with the bolt.
88467B 4.INSTALL LOWER COOLER BRACKET RH
Install the lower cooler bracket RH with the bolt.
88467B 5.INSTALL UPPER COOLER BRACKET LH
Install the upper cooler bracket LH with the bolt.
88467B 6.INSTALL UPPER COOLER BRACKET RH
Install the upper cooler bracket RH with the bolt.
88716A 7.INSTALL COOLER REFRIGERANT LIQUID PIPE A
Remove the attached vinyl tape from the tube and the connecting part of the cooler condenser assembly.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the tube joint.
ND-OIL 8 or equivalent
Install the O-ring on the cooler refrigerant liquid pipe A.
Install the cooler refrigerant liquid pipe A on the cooler condenser assembly with the bolt.
When tightening the bolt, do not allow any tools to contact the pipe.
When tightening the bolt, hold a part of the pipe near the connector.
88474 8.INSTALL COOLER DRYER
Using pliers, install the cooler dryer.
Apply a sufficient amount of compressor oil to the contact surfaces of a new O-ring and the cap.
ND-OIL 8 or equivalent
Install the O-ring to the cap.
Using a 14 mm socket hexagon wrench, install the cap to the modulator.