25860A 1.INSPECT NO. 1 VACUUM SWITCHING VALVE
| *a | Component without harness connected (Vacuum Switching Valve) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | 20°C (68°F) | 37 to 44 Ω |
| 1 - Body ground 2 - Body ground |
20°C (68°F) | 1 MΩ or higher |
If the result is not as specified, replace the No. 1 vacuum switching valve.
| *1 | Port E |
| *2 | Port F |
| *3 | Vacuum |
| *4 | Air |
| *5 | Filter |
Check operation of the No. 1 vacuum switching valve.
When a vacuum of 67 kPa (500 mmHg, 19.7 in.Hg) is applied to port F, check that air flows from port E to the filter.
| *1 | Port E |
| *2 | Port F |
| *3 | Air |
Apply battery voltage across terminals 1 and 2.
Check that air flows from port E to port F.
If the result is not as specified, replace the No. 1 vacuum switching valve.