Use the same procedure for LHD and RHD vehicles.
The procedures listed below are for LHD vehicles.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
86396 2.REMOVE ANTENNA NUT
Remove the antenna nut as shown in the illustration.
86392 3.REMOVE ANTENNA ORNAMENT
Remove the antenna ornament as shown in the illustration.
55480D 4.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for Driver Side)
55550 5.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for Passenger Side)
86300 6.REMOVE ANTENNA ASSEMBLY (for Auto Type Antenna)
Disconnect the connector.
Detach the antenna assembly from the clamp and push out the grommet from inside the vehicle.
Disconnect the connector and remove the nut.
Remove the antenna assembly from the engine room hole.
86300 7.REMOVE ANTENNA ASSEMBLY (for Manual Type Antenna)
Detach the antenna assembly from the clamp and push out the grommet from inside the vehicle.
Remove the nut. Then remove the antenna assembly from the engine room hole.
85914A 8.REMOVE ANTENNA MOTOR CONTROL RELAY
Disconnect the connector.
Remove the 2 bolts and antenna motor control relay.