Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
82143 1.INSTALL NO. 3 INSTRUMENT PANEL WIRE
When handling the airbag connector, take care not to damage the airbag wire harness.
| *1 | Connector Lock |
Attach the wire harness clamp to install the No. 3 instrument panel wire.
Connect the airbag connector and lock the connector lock.
73970A 2.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Attach the wire harness clamp.
Attach the 2 guides and 14 claws to install the instrument panel passenger airbag assembly.
Install the 2 bolts.
| *1 | Slider |
| *a | Lock Position |
Connect the airbag connector and check that the slider is in the lock position.
When handling the airbag connector, take care not to damage the airbag wire harness.
If the slider is not in the lock position, the airbag connector is not completely connected. Disconnect the airbag connector, check the airbag connector and instrument panel wire terminals and connector housings for deformation or foreign matter, and then reconnect the airbag connector.
55433B 3.INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
Attach the 2 guides.
Attach the 3 claws to install the lower No. 2 instrument panel finish panel.
55550 4.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6.PERFORM DIAGNOSTIC SYSTEM CHECK
7. CHECK SRS WARNING LIGHT