1. PRECAUTION
Be sure to read precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
58811B 3.REMOVE CONSOLE BOX
89179A 4.REMOVE AIRBAG SENSOR COVER
Remove the 3 bolts and airbag sensor cover.
89175 5.REMOVE AIRBAG SENSOR BRACKET
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Do not remove the waterproof sheet.
If the center airbag sensor assembly has been dropped, replace it with a new one.
| *1 | Connector Lock Lever |
| *2 | Waterproof Sheet |
Disconnect the airbag connector.
Push and pull the connector lock lever to release the connector lock as shown in the illustration.
Disconnect the airbag connector.
Remove the 3 bolts and airbag sensor bracket together with the center airbag sensor assembly.
89170 6.REMOVE CENTER AIRBAG SENSOR ASSEMBLY
Remove the 3 bolts and center airbag sensor assembly from the airbag sensor bracket.
Do not remove the waterproof sheet.
If the center airbag sensor assembly has been dropped, replace it with a new one.