Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
42312 1.REMOVE REAR AXLE SHAFT LH
Remove the 6 nuts and 6 washers.
Using a brass bar and hammer, tap out the bolts and remove the 6 cone washers.
Install the 2 service bolts to the service hole.
Remove the rear axle shaft together with the rear axle shaft outer flange gasket.
Remove the 2 service bolts from the rear axle shaft.
42312C 2.REMOVE REAR AXLE SHAFT OIL SEAL LH
Using SST, remove the rear axle shaft oil seal LH.