Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
48331C 1.INSTALL FRONT SPRING BUMPER LH
Install the front spring bumper LH to the frame with the 2 bolts.
48310A 2.INSTALL FRONT SUSPENSION HOLLOW SPRING ASSEMBLY LH
Install the front suspension hollow spring assembly LH to the frame with the 2 nuts.
48132 3.INSTALL FRONT COIL SPRING LH
Using SST, compress the front coil spring LH.
Do not use an impact wrench.
Install the front coil spring LH to the front axle housing assembly.
Before installing the front coil spring LH, check that the coil spring end is in the correct position. If not, reinstall the front coil spring LH.
Jack up the front axle housing assembly.
Remove SST from the front coil spring LH.
Do not use an impact wrench.
48811 4.TEMPORARILY INSTALL FRONT STABILIZER BAR
Temporarily install the front stabilizer bar to the front axle housing assembly with the bolt and nut.
48520 5.INSTALL FRONT SHOCK ABSORBER ASSEMBLY LH
6.INSTALL FRONT WHEEL
7.STABILIZE SUSPENSION
Lower the vehicle.
Bounce the vehicle up and down at the corners several times to stabilize the suspension.
48811 8.TIGHTEN FRONT STABILIZER BAR
Tighten the bolt and nut of the front stabilizer bar.