1.REMOVE FRONT WHEEL
2.REMOVE WIRE HARNESS CLAMP (w/ Differential Lock)
Remove the bolt and disconnect the wire harness clamp assembly.
48520 3.DISCONNECT FRONT SHOCK ABSORBER ASSEMBLY LH (for 1GR-FE)
| *a | Wooden or Rubber Block |
Support the front axle housing assembly with a jack.
Place a wooden or rubber block between the jack and arm.
Hold the front shock absorber and remove the lower mounting nut and front No. 2 shock absorber cushion retainer.
48510 4.DISCONNECT FRONT SHOCK ABSORBER ASSEMBLY RH (for 1GR-FE)
Use the same procedure described for the LH side.
48811 5.REMOVE FRONT STABILIZER BAR
Remove the 4 bolts and disconnect the front stabilizer bar from the front stabilizer links.
Remove the bolt, nut and front stabilizer bar from the front axle housing assembly.
Use the same procedure described for the other side.
48802F 6.REMOVE FRONT STABILIZER LINK SUB-ASSEMBLY LH
Remove the nut, washer and front stabilizer link sub-assembly from the front No. 1 stabilizer bracket.
48802F 7.REMOVE FRONT STABILIZER LINK SUB-ASSEMBLY RH
Use the same procedure described for the LH side.
48815 8.REMOVE FRONT NO. 1 STABILIZER BAR BUSHING
Remove the 2 front No. 1 stabilizer bar bushings from the front stabilizer bar.
48829A 9.REMOVE FRONT NO. 1 STABILIZER BRACKET LH
except 1GR-FE:
Remove the 4 bolts and front No. 1 stabilizer bracket from the chassis frame.
for 1GR-FE:
Remove the 3 bolts and front No. 1 stabilizer bracket from the chassis frame.
48824A 10.REMOVE FRONT NO. 1 STABILIZER BRACKET RH
Use the same procedure described for the LH side.
11.REMOVE BUSHING
Remove the 2 collars and 2 bushings from the front stabilizer bar.