Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR
RM25T0E _53 Suspension _029909 FRONT SUSPENSION _0138027 FRONT STABILIZER BAR G

FRONT SUSPENSION  FRONT STABILIZER BAR  INSPECTION  


PROCEDURE

Hide 48802F 1.INSPECT FRONT STABILIZER LINK SUB-ASSEMBLY

a.
C124387

Temporarily install the nut and flip the ball joint stud back and forth 5 times as shown in the illustration.


b.

Use a torque wrench to turn the nut continuously at a rate of 2 to 3 seconds per turn. Take a torque reading on the fifth turn.

Standard turning torque:

0.5 to 3.4 N*m (5.1 to 36 kgf*cm, 4.4 to 30 in.*lbf)


If the turning torque is not within the specified range, replace the stabilizer link with a new one.