Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
48610A 2.REMOVE FRONT LEADING ARM ASSEMBLY
| *a | Wooden or Rubber Block |
Support the front axle housing assembly with a jack.
Place a wooden or rubber block between the jack and arm.
Remove the front leading arm assembly from the frame with the bolt, washer and nut.
Remove the front leading arm assembly from the front axle housing assembly with the 2 bolts and 2 nuts.
Since a stopper nut is used, remove the bolt.
48654 3.REMOVE LOWER ARM BUSH
Using SST and a press, remove the lower arm bush.