84930 1.INSPECT DOOR CONTROL SWITCH ASSEMBLY
| *a | Component without harness connected |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 3 (L) - 6 (E) | Lock | Below 1 Ω |
| 3 (L) - 6 (E) 5 (UL) - 6 (E) |
OFF | 10 kΩ or higher |
| 5 (UL) - 6 (E) | Unlock | Below 1 Ω |
If the result is not as specified, replace the door control switch assembly.
Apply battery voltage between the terminals of the door control switch assembly, and check the illumination of the door control switch assembly.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 2 |
Illuminates |
If the result is not as specified, replace the door control switch assembly.