Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
1.INSTALL DOOR CONTROL RECEIVER
Connect the connector.
Install the door control receiver with the bolt.
55446A 2.INSTALL NO. 1 SWITCH HOLE BASE
55409F 3.INSTALL NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
55480D 4.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY