Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.SECURE STEERING WHEEL
Secure the steering wheel assembly with the seat belt in order to prevent rotation.
This operation is useful to prevent damage to the spiral cable.
2.REMOVE FRONT WHEEL
53737B 3.REMOVE FRONT FENDER APRON SEAL LH
Detach the 3 clips fold back the front fender apron seal LH.
45636B 4.REMOVE INTERMEDIATE LINK JOINT PROTECTOR
Remove the bolt and intermediate link joint protector.
45203 5.DISCONNECT NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY
Loosen the 2 bolts of the steering sliding yoke.
| *a | Matchmark |
Remove the bolt.
Put the matchmarks on the No. 2 steering intermediate shaft sub-assembly and power steering gear assembly.
Disconnect the No. 2 steering intermediate shaft sub-assembly from the power steering gear assembly.
44251 6.DISCONNECT PITMAN ARM
Loosen the pitman arm nut.
Using SST, disconnect the pitman arm from the cloth shaft.
Remove the nut and spring washer.
Disconnect the pitman arm.
7.DRAIN POWER STEERING FLUID
44110 8.REMOVE POWER STEERING GEAR ASSEMBLY
Using a union nut wrench disconnect the steering gear outlet return tube and pressure feed tube assembly.
Remove the 4 nuts and 4 bolts, remove the power steering gear assembly.