A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
52581A 1.INSTALL REAR BUMPER FILLER PROTECTOR
Use the same procedure for all rear bumper filler protector.
Install the rear bumper filler protector.
Install a nose piece to an air riveter or hand riveter.
Insert the mandrel part of a new rivet into the nose piece.
Place the riveter upright against the rear bumper filler protector and install the rivet.
If the rivet cannot be cut, pull it once and cut it.
| *1 | Riveter |
| *2 | Mandrel |
| *a | INCORRECT |
| *b | CORRECT |
Do not pry the rivet with the riveter as this will cause damage to the riveter and mandrel.
| *1 | Riveter |
| *a | INCORRECT |
| *b | CORRECT |
Confirm that the rivets are seated properly against the rear bumper filler protector.
Do not tilt the riveter when installing the rivet to the rear bumper filler protector.
Do not leave any space between the rivethead and rear bumper filler protector.
| *1 | Riveter |
| *a | INCORRECT |
| *b | CORRECT |
Do not leave any space between the rear bumper filler protector and front door panel.Firmly hold together the 2 items while installing the rivet.
52463 2.INSTALL REAR BUMPER PAD LH
Install the rear bumper pad LH with the bolt.
52462 3.INSTALL REAR BUMPER PAD RH
Use the same procedure described for the LH side.
52168B 4.INSTALL REAR BUMPER EXTENSION MOUNTING BRACKET LH
Install the rear bumper extension mounting bracket LH with the 2 bolts.
52185B 5.INSTALL REAR BUMPER SIDE MOUNTING BRACKET RH
Install the rear bumper side mounting bracket RH to the rear bumper side support RH with the 2 bolts.
52163A 6.INSTALL REAR BUMPER PLATE RH
Install the rear bumper plate RH with the 11 bolts and 3 nuts to the rear bumper arm RH, rear bumper No. 1 plate and rear bumper sub-assembly RH.
52151E 7.INSTALL REAR BUMPER BAR
Install the rear bumper bar with the 4 bolts and 3 nuts.
52164A 8.INSTALL REAR BUMPER PLATE LH
Install the rear bumper plate LH to the rear bumper sub-assembly LH with the 4 bolts and 3 nuts.
52109A 9.INSTALL REAR SIDE BUMPER SUB-ASSEMBLY LH
Install the rear side bumper sub-assembly LH with the 2 nuts.
52108A 10.INSTALL REAR SIDE BUMPER SUB-ASSEMBLY RH
Use the same procedure described for the LH side.