1.DRAIN TRANSFER OIL
| *1 | No. 1 Transfer Case Plug (Filler Plug) |
| *2 | Transfer Drain Plug |
Remove the No. 1 Transfer Case Plug (Filler Plug) and No. 1 transfer case gasket.
Remove the transfer drain plug and transfer drain plug gasket, and drain the transfer oil.
Install a new transfer drain plug gasket to the transfer drain plug and then install the transfer drain plug.
2.ADD TRANSFER OIL
| *a | 0 to 5.0 mm (0 to 0.196 in.) |
Pour oil so that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the filler plug hole.
| Oil grade | Oil viscosity |
|---|---|
| API GL-4 or GL-5 | SAE 75W-90 |
1.5 liters (1.6 US qts, 1.3 Imp. qts)
When adding oil, pour it slowly.
Add oil a little at a time, waiting several minutes between each addition of oil.
Too much or too little oil will lead to transfer problems.
Wait approximately 5 minutes and check that the oil level has not changed.
Install a new No. 1 transfer case gasket to the No. 1 Transfer Case Plug (Filler Plug) and then install the No. 1 Transfer Case Plug (Filler Plug).