Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster.
1.DRAIN BRAKE FLUID
Wash off brake fluid immediately if it comes in contact with any painted surface.
2.DISCONNECT BRAKE FLUID LEVEL WARNING SWITCH CONNECTOR
Disconnect the brake fluid level warning switch connector.
| *A | for LHD | *B | for RHD |
31434 3.DISCONNECT CLUTCH RESERVOIR TUBE (for LHD)
Slide the clip and disconnect the clutch reservoir tube from the master cylinder reservoir.
47311 4.DISCONNECT FRONT NO. 1 BRAKE TUBE
Using a union nut wrench, disconnect the front No. 1 brake tube from the brake master cylinder.
| *A | for LHD | *B | for RHD |
47322 5.DISCONNECT REAR NO. 2 BRAKE TUBE
Using a union nut wrench, disconnect the front No. 2 brake tube from the brake master cylinder.
| *A | for LHD | *B | for RHD |
47201 6.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
for 1GR-FE:
| *A | for LHD |
| *B | for RHD |
Remove the 2 nuts.
Pull out brake master cylinder from the brake booster.
Make sure foreign matter does not attach to the master cylinder piston. If foreign matter attaches, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.
Remove the brake master cylinder gasket from the brake master cylinder.
| *A | for LHD |
| *B | for RHD |
for 1HZ:
Remove the 2 nuts.
Pull out brake master cylinder from the brake booster.
Make sure foreign matter does not attach to the master cylinder piston. If foreign matter attaches, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.
Remove the brake master cylinder gasket from the brake master cylinder.