Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER (w/o ABS)
RM25T0E _54 Brake _029916 BRAKE SYSTEM (OTHER) _0138393 BRAKE MASTER CYLINDER(w/o ABS) G

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(w/o ABS)  INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:

Make sure foreign matter does not attach to the master cylinder piston. If foreign matter attaches, clean it off with a cloth. then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.


PROCEDURE

Hide 1.INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD

HINT:

Adjust the booster push rod when the master cylinder is replaced with a new one. Adjustment is not necessary when the master cylinder is reinstalled and the booster is replaced with a new one.


a.
C160627N01
1.677,1.583 1.99,1.302 1.99,1.302 2.448,1.302 false 1.323,4.51 1.052,4.51 1.052,4.51 1.052,4.302 false 2.479,1.219 2.938,1.417 0.458,0.198 10 false SST 1.365,4.427 1.823,4.625 0.458,0.198 10 false SST

Set SST on the master cylinder and lower the rod of SST until it touches the piston.

SST
09737-00013  

HINT:

SST: 09737-00012 can also be used.



b.

Apply chalk to the flat tip of SST rod. Turn SST upside down and measure the clearance between the brake booster push rod and SST.

Standard Clearance:
Item Specified Condition
for 1GR-FE 0.14 to 0.35 mm (0.00552 to 0.0137 in.)
for 1HZ 0.25 to 0.5 mm (0.00985 to 0.0196 in.)
for 1VD-FTV


If there is clearance between SST main body and the shell of the brake booster, the push rod is protruding too far. If the chalk does not stick to the tip of the brake booster push rod, the push rod protrusion is insufficient.


c.
C132720N13
0.656,0.635 1.125,0.521 true 0.281,0.552 0.875,0.771 0.594,0.219 10 false SST

If the clearance is not within the standard, adjust the length by holding the rod using SST and turning the tip of the rod using a 7 mm socket driver.

SST
09737-00020  

NOTICE:

Check the push rod clearance again after adjusting.