Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER (w/o ABS) › 2014.08–2017.09
RM25T0E _54 Brake _029916 BRAKE SYSTEM (OTHER) _0138393 BRAKE MASTER CYLINDER(w/o ABS) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(w/o ABS)  INSTALLATION  


PROCEDURE

Hide 47201 1.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

a.

for 1GR-FE:

i.

Install the master cylinder to the brake booster with the 2 nuts.

Torque:
12.5 N*m (127 kgf*cm, 9 ft.*lbf)

NOTICE:

Make sure foreign matter does not attach to the master cylinder piston. If foreign matter attaches, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.




b.

for 1HZ:

i.

Install a new gasket to the master cylinder.


ii.

Install the master cylinder to the brake booster with the 2 nuts.

Torque:
12.5 N*m (127 kgf*cm, 9 ft.*lbf)

NOTICE:

Make sure foreign matter does not attach to the master cylinder piston. If foreign matter attaches, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.




Hide 47311 2.INSTALL FRONT NO. 2 BRAKE TUBE

a.
C313506C01
1.292,2.667 1.604,2.865 0.313,0.198 10 false *a
*a Torque Wrench Fulcrum Length


Using a union nut wrench, connect the front No. 2 brake tube to the master cylinder.

Torque:
Specified tightening torque : 15.2 N*m (155 kgf*cm, 11 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)




Hide 47311 3.INSTALL FRONT NO. 1 BRAKE TUBE

a.
C313505C01
0.833,2.25 1.146,2.448 0.313,0.198 10 false *a
*a Torque Wrench Fulcrum Length


Using a union nut wrench, connect the front No. 1 brake tube to the master cylinder.

Torque:
Specified tightening torque : 15.2 N*m (155 kgf*cm, 11 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)




Hide 31434 4.CONNECT CLUTCH RESERVOIR TUBE (for LHD)

a.

Connect the clutch reservoir tube to the brake master cylinder reservoir.


Hide 5.CONNECT BRAKE FLUID LEVEL WARNING SWITCH

a.

Connect the brake fluid level warning switch connector.


Hide 7.BLEED CLUTCH LINE (for LHD)