1.REMOVE VACUUM HOSE UNION
Remove the union bolt, union and 2 gaskets.
2.REMOVE CHECK VALVE SUB-ASSEMBLY
Remove the check valve and gasket.
3.REMOVE VACUUM PUMP END COVER
Remove the 3 bolts.
Using a 5 mm pin punch and hammer, tap out the 2 straight pins.
Remove the end cover and O-ring.
4.REMOVE VACUUM PUMP ROTOR SUB-ASSEMBLY
Remove the vacuum pump rotor sub-assembly.
5.REMOVE VACUUM PUMP BLADE
Remove the 5 vacuum pump blades from the vacuum pump rotor.
Be careful not to drop the blades.
6.REMOVE VACUUM PUMP GEAR
Remove the lock nut.
Remove the vacuum pump gear and woodruff key.
7.REMOVE HOLE SNAP RING
Using snap ring pliers, remove the snap ring.
8.REMOVE VACUUM PUMP SHAFT
Using a plastic-faced hammer, tap out the vacuum pump shaft.
9.REMOVE BEARING
Using a 17 mm socket wrench and press, press out the bearing from the vacuum pump housing.