Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP(for 1HZ)
RM25T0E _54 Brake _029916 BRAKE SYSTEM (OTHER) _0138395 VACUUM PUMP(for 1HZ) A

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for 1HZ)  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL BEARING

a.
C160660

Using a press, press in a new bearing to the shaft.


Hide 2.INSTALL VACUUM PUMP SHAFT

a.
C160661N01
0.667,0.25 0.885,0.25 0.885,0.25 1.625,0.656 true 0.375,0.167 0.833,0.365 0.458,0.198 10 false SST

Using SST and a press, press in the shaft to the housing.

SST
09608-04031  


Hide 3.INSTALL HOLE SNAP RING

a.
C160655

Using snap ring pliers, install a new snap ring.

NOTICE:

Make sure that the snap ring is firmly installed to the groove.



Hide 4.INSTALL VACUUM PUMP GEAR

a.
C160662

Install the woodruff key and gear to the pump with the lock nut.

Torque:
110.3 N*m (1125 kgf*cm, 81 ft.*lbf)


Hide 5.INSTALL VACUUM PUMP ROTOR SUB-ASSEMBLY

a.
C160663

Apply engine oil to the rotor and install it to the shaft.


Hide 6.INSTALL VACUUM PUMP BLADE

a.

Install 5 new blades with the round end facing outward.

HINT:
·

Apply engine oil to the blade.

·

Make sure that the blades are flush with the rotor surface.




Hide 7.INSTALL VACUUM PUMP END COVER

a.

Install a new O-ring.


b.
C160651

Install the end cover and temporarily install the 3 bolts.


c.
C160652

Using a 5 mm pin punch and hammer, tap in the 2 straight pins.


d.

Tighten the 3 bolts.

Torque:
7.9 N*m (81 kgf*cm, 70 in.*lbf)


Hide 8.INSTALL CHECK VALVE SUB-ASSEMBLY

a.

Install a new gasket and the check valve sub-assembly.

Torque:
73.5 N*m (749 kgf*cm, 54 ft.*lbf)


Hide 9.INSTALL VACUUM HOSE UNION

a.
C160649

Install 2 new gaskets and the union with the union bolt.

Torque:
13.7 N*m (140 kgf*cm, 10 ft.*lbf)

HINT:

Align and insert the union pin into the matching hole of the housing.