When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
1.REMOVE SPIDER BEARING
Use the same procedure for both spiders.
| *a | Matchmark |
Place matchmarks on the flange yoke and propeller shaft.
Using a brass bar and hammer, slightly tap in the spider bearing outer races.
Using 2 screwdrivers, remove the 4 front propeller shaft joint spider bearing snap rings from the grooves.
| *a | Turn |
| *b | Hold |
Using SST, remove the spider bearing from the front propeller shaft assembly.
Before installing SST, sufficiently raise the part labeled A. If the part labeled A is too low, it may be difficult to install SST.
| *a | Hammering Point |
Remove the flange yoke with a hammer.
Remove the spider bearing on the opposite side using the same procedure.
Do not tap the shaft.
Remove the flange yoke from the front propeller shaft assembly.
| *a | Turn |
| *b | Hold |
Install the 2 removed spider bearing outer races to the spider.
Using SST, remove the spider bearing from the flange yoke.
Before installing SST, sufficiently raise the part labeled A. If the part labeled A is too low, it may be difficult to install SST.
| *a | Hammering Point |
Tap off the flange yoke with a hammer.
Remove the spider.