1.INSPECT TRANSFER INDICATOR SWITCH (4WD POSITION AND L4 POSITION)
Inspect the No. 1 transfer indicator switch (4WD position).
| *a | Component without harness connected (No. 1 transfer indicator switch (4WD position)) |
| *b | Pushed |
| *c | Released |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Pushed | Below 1 Ω |
| Released | 10 kΩ or higher |
If the result is not as specified, replace the No. 1 transfer indicator switch (4WD position).
Inspect the No. 1 transfer indicator switch (L4 position).
| *a | Component without harness connected (No. 1 transfer indicator switch (L4 position)) |
| *b | Pushed |
| *c | Released |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Pushed | Below 1 Ω |
| Released | 10 kΩ or higher |
If the resistance is not as specified, replace the No. 1 transfer indicator switch (L4 position).