Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR(w/ ABS) › 2014.08–2016.08
RM25T0E _54 Brake _029873 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0138476 BRAKE ACTUATOR(w/ ABS) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR(w/ ABS)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 3.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 44510 4.REMOVE BRAKE ACTUATOR ASSEMBLY WITH BRACKET

a.
C267644E02
2.548,0.881 2.706,1.029 0.158,0.148 10 *1 2.403,0.373 2.554,0.517 0.150,0.144 10 *2 1.347,1.791 1.497,1.944 0.150,0.154 10 *3 2.864,2.071 3.016,2.214 0.152,0.143 10 *4 2.642,3.031 2.793,3.174 0.152,0.143 10 *5 1.641,1.541 1.428,1.702 1.428,1.702 1.428,1.782 false 2.025,1.748 2.025,3.11 2.025,3.11 2.621,3.11 false 2.383,1.491 2.383,2.15 2.383,2.15 2.839,2.15 false 2.041,1.246 2.32,0.967 2.32,0.967 2.537,0.967 false 1.828,1.342 1.828,0.449 1.828,0.449 2.391,0.449 false

Place tags or marks to identify the installation locations of each brake line.

HINT:
·

*1: to front wheel cylinder RH

·

*2: to front wheel cylinder LH

·

*3: to rear wheel cylinder

·

*4: to master cylinder front

·

*5: to master cylinder rear




b.

Pull the lock lever upward and disconnect the connector.

NOTICE:

Be careful not to allow brake fluid to enter the removed connector.



c.
C267645

Using a union nut wrench, disconnect the 5 brake lines from the brake actuator.


d.
C267646

Remove the 3 nuts and brake actuator with bracket.

NOTICE:

Be careful not to damage the brake tubes.