44510 1.INSTALL BRAKE ACTUATOR ASSEMBLY WITH BRACKET
Install the brake actuator with bracket with the 3 nuts.
Be careful not to damage the brake tubes.
Tighten the 3 nuts uniformly in alphabetical order.
Set each brake line in the correct position on the brake actuator as shown in the illustration.
*1: to front wheel cylinder RH
*2: to front wheel cylinder LH
*3: to rear wheel cylinder
*4: to master cylinder front
*5: to master cylinder rear
| *a | Torque Wrench Fulcrum Length |
Using a union nut wrench, connect the 5 brake lines to the correct locations on the actuator as shown in the illustration.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)
Connect the connector.
Make sure that the connector is locked securely.
2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
3.BLEED BRAKE SYSTEM
4.BLEED CLUTCH LINE
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM>BLEEDING
44510 5.CHECK BRAKE ACTUATOR WITH GTS