The procedure listed below is for the LH side.
Other than areas where instructions are provided, use the same procedure for the LH and RH sides.
1.REMOVE FRONT WHEEL
89516D 2.REMOVE SKID CONTROL SENSOR WIRE
Disconnect the connector.
| *a | for LH | *b | for RH |
Remove the bolt and harness clamp.
Remove the bolt and harness clamp.
| *a | for LH | *b | for RH |
for 1GR-FE:
Remove the bolt and harness clamp.
| *a | for LH | *b | for RH |
for 1HZ, 1VD-FTV:
Remove the bolt and harness clamp.
| *a | for LH | *b | for RH |
Disconnect the front speed sensor connector.
Detach the connector clamp.
Remove the 2 bolts and 2 harness clamps.
89543 3.REMOVE FRONT SPEED SENSOR LH
Remove the nut and front speed sensor LH.
Keep the sensor tip and sensor installation hole free from foreign matter.