Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE CYLINDER BOOT
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, remove the 4 set rings and 4 cylinder boots from the disc brake cylinder assembly LH.
Tape the screwdriver tip before use.
Be careful not to damage the brake piston and disc brake cylinder assembly LH.
47731 2.REMOVE FRONT DISC BRAKE PISTON
| *a | 170 mm (6.70 in.) |
| *b | 50 mm (1.97 in.) |
| *c | 25 mm (0.99 in.) |
Prepare a wooden plate to hold the front disc brake pistons.
Place the wooden plate between the front disc brake pistons and insert a front disc brake pad on one side.
Use compressed air to remove the 4 front disc brake pistons from the disc brake cylinder assembly LH.
Do not place your finger in front of the piston when using compressed air.
Be careful not to spatter the brake fluid.
3.REMOVE PISTON SEAL
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, remove the 4 piston seals from the disc brake cylinder assembly LH.
Tape the screwdriver tip before use.
Be careful not to damage the inner cylinder and cylinder groove.
47714 4.REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP
47713 5.REMOVE FRONT DISC BRAKE BLEEDER PLUG