Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
47313A 1.INSTALL FRONT FLEXIBLE HOSE (for 1HZ, 1VD-FTV)
Attach a new clip to the front flexible hose.
Connect the front flexible hose to the 3-way.
| *a | Torque Wrench Fulcrum Length |
Using a union nut wrench, connect the front flexible hose to the brake line while holding the front flexible hose with a wrench.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)
Do not bent or damage the brake line.
Do not allow any foreign matter such as dirt and dust to enter the brake line from the connecting point.
47313A 2.INSTALL FRONT FLEXIBLE HOSE (for 1GR-FE)
Attach a new clip to the front flexible hose.
Connect the front flexible hose to the 3-way.
| *a | Torque Wrench Fulcrum Length |
Using a union nut wrench, connect the front flexible hose to the brake line while holding the front flexible hose with a wrench.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum lengtj of 162 mm (6.3779 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)
Do not bent or damage the brake line.
Do not allow any foreign matter such as dirt and dust to enter the brake line from the connecting point.
47313A 3.INSTALL FRONT FLEXIBLE HOSE LH
Connect the front flexible hose LH to the connecting point with the brake line, and install a new clip.
| *a | Torque Wrench Fulcrum Length |
Using a union nut wrench, connect the brake line to the front flexible hose LH while holding the front flexible hose LH with a wrench.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm(6.3779 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)
Do not bend or damage the brake line.
Do not allow any foreign matter such as dirt and dust to enter the brake line from the connecting point.
Install the front flexible hose LH and a new gasket to the front disc brake cylinder assembly LH with a new union bolt.
Install the flexible hose lock securely to the lock hole in the front disc brake cylinder assembly LH.
4.BLEED BRAKE SYSTEM
5.BLEED CLUTCH LINE
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM>BLEEDING
6.INSTALL FRONT WHEEL