Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
2.DRAIN BRAKE FLUID
Wash off brake fluid immediately if it comes in contact with any painted surface.
47319F 3.DISCONNECT REAR FLEXIBLE HOSE LH
Remove the union bolt and gasket.
Disconnect the rear flexible hose LH from the rear disc brake cylinder assembly LH.
47787A 4.REMOVE DUST BOOT PROTECTOR LH
Remove the 2 bolts and dust boot protector LH from the rear disc brake cylinder assembly LH.
47750A 5.REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY LH
Remove the 2 rear disc brake cylinder slide pins from the rear disc brake cylinder assembly LH.
Remove the rear disc brake cylinder assembly LH from the rear disc brake cylinder mounting LH.
04466 6.REMOVE REAR DISC BRAKE PAD
Remove the 2 rear disc brake pads together with the rear disc brake anti-squeal shims from the rear disc brake cylinder mounting LH.
04946 7.REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM
Remove the 2 rear disc brake anti-squeal shims from the rear disc brake pads.
47771A 8.REMOVE REAR DISC BRAKE PAD WEAR INDICATOR PLATE
Remove the rear disc brake pad wear indicator plate from the inner side disc brake pad.
47716A 9.REMOVE REAR NO. 1 DISC BRAKE PAD SUPPORT PLATE
If it is necessary to remove the pad support plates, replace them with new ones.
| *1 | Rear No. 1 Disc Brake Pad Support Plate |
| *2 | Rear No. 2 Disc Brake Pad Support Plate |
Remove the 2 rear No. 1 disc brake pad support plates from the rear disc brake cylinder mounting LH.
47717A 10.REMOVE REAR NO. 2 DISC BRAKE PAD SUPPORT PLATE
If it is necessary to remove the pad support plates, replace them with new ones.
Remove the 2 rear No. 2 disc brake pad support plates from the rear disc brake cylinder mounting LH.
47722A 11.REMOVE REAR DISC BRAKE CYLINDER MOUNTING LH
Remove the 2 bolts, 2 plate washers and rear disc brake cylinder mounting LH.
47775D 12.REMOVE REAR DISC BRAKE BUSH DUST BOOT
Remove the rear disc brake bush dust boot from the rear disc brake cylinder mounting LH.
47769A 13.REMOVE REAR DISC BRAKE CYLINDER SLIDE BUSH
Remove the rear disc brake cylinder slide bush from the rear disc brake cylinder mounting LH.
47713A 14.REMOVE REAR DISC BRAKE CYLINDER HOLE PLUG
Remove the rear disc brake cylinder hole plug from the rear disc brake cylinder mounting LH.
42491 15.REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG
Remove the parking brake shoe adjusting hole plug from the rear disc.
42431 16.REMOVE REAR DISC
| *a | Matchmark |
Place matchmarks on the rear disc and axle hub if planning to reuse the disc.
| *a | Shoe Adjuster Contracts |
Turn the shoe adjuster until the disc turns freely, and then remove the disc.