Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
2.DRAIN BRAKE FLUID
Wash off brake fluid immediately if it comes in contact with any painted surface.
47319F 3.REMOVE REAR FLEXIBLE HOSE LH
Remove the union bolt and gasket.
Disconnect the rear flexible hose LH from the rear disc brake cylinder assembly LH.
Disconnect the brake tube from the flexible hose with a union nut wrench while holding the flexible hose with a wrench.
Do not bend or damage the brake tube.
Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.
Remove the clip.
47319F 4.REMOVE REAR FLEXIBLE HOSE
Disconnect the brake tube and 3-way from the flexible hose with a union nut wrench while holding the flexible hose with a wrench.
Do not bend or damage the brake tube.
Do not allow any foreign matter such as dirt and dust to enter the brake tube and 3-way from the connecting points.
Remove the clip and flexible hose.